12.) The fill-up of the water is concluded. Now the ampere-hour counter and the warning
lamp “refill water“ will be reset. Connect the ReLight2010 to the car and go to the menu
„reset water“ and press "ENTER".
13.)
You should now see „reset water?“ „Yes:<ENTER>…“ . Press „enter“ again.
14.)
Now the ReLight2010 will restart itself and the warning light „refill water“ goes out
(if it weren’t already). Draw off the ReLight if it indicates "RESTART".
15.)
Wait after the separation of the ReLights 10 seconds and switch on the
ignition (wait 5 - 10 seconds) and then off again.
16.) Connect the ReLight2010 again and make sure that the overcharge counter shows 0 (only
Mode1) and that all loads are inactive (no three horizontal beams).
FINISHED.
Attention: with older models no overcharge information is indicated! Here this step can be
cancelled.
Remark: The complete procedure should be concluded within 30 minutes. Normally it lasts
approx. 15 minutes.
