44
80-1403-01, Rev. 3
Thrust Setup Menu
(Block 15)
Inactive for Group 14.
Status Menu
(Block 16)
This menu provides a path to parameters that
monitor the operational status of the actuator. It
also includes the display of one parameter.
5 Line Freq
: The power line frequency as
measured by the DCM-3
Tests Menu
(Block 17)
The Tests menu provides access to some
routines that help determine if the actuator is
running properly.
1 FB Out Test
: Allows a technician to manually
vary the Feedback output signal to check
operation and accuracy. (SHAFT POSITION
OUTPUT SIGNAL, page 31)
2 Board Self-Test
: Instructs the DCM-3 to check
various power and sensing circuits. This test
should not be run unless sudden output shaft
movements are allowable
3 Identify Device
: Sends a HART command to
the DCM-3 that causes the ACKNOWLEDGE
LED to flash. This is to make certain the HART
system is addressing the correct actuator
4 Board Reset
: Causes the DCM-3 to go
through a reset cycle similar to a power-up
reset. This test should not be run unless
sudden output shaft movements are allowable
Retract Thrust Menu
(Block 18)
Inactive for Group 14.
Extend Thrust Menu
(Block 19)
Inactive for Group 14.
Alarm Setup Menu
(Block 20)
The Alarm Setup menu parameters allow
modification of the behavior of the alarm output
solid state relay.
1 AlarmPol
: Whether the solid state relay
opens on alarm or closes on alarm. (ALARM
OUTPUT CONFIGURATION, page 23)
2 Alarm Mask
: Which alarms cause the solid
state relay to change state. (ALARM OUTPUT
CONFIGURATION, page 23)
DCM-3 HART
Menus
