Beastx Aircraft, Instruction Manual, Page: 78 / 88

78
Description Reason Solutions
Selection in the menus with
the rudder control stick does
not work .
Too little control travel
on the rudder channel.
Connector from the
rudder channel
inserted incorrectly.
- Increase the servo throw / dual rate
for the rudder channel in the TX.
- Check that the connector for the
rudder channel (orange wire) is
inserted correctly in the receiver.
The sensors do not seem to
work correctly .
The tail servo does not react or
reacts very slowly to rotation of
the helicopter. The same
happens to the elevator axis.
Wrong mounting
orientation has been
selected.
The gain of tail gyro is
too low in the
transmitter or even not
on the right channel
- In setup menu point
A
select the
correct mounting orientation.
- Adjust the Gain in the transmitter
- Correct wiring or setup of tail gain
cable/channel.
The helicopter slowly drifts
by itself on aileron, elevator
and/or tail .
The swashplate is perfectly
leveled and no sub trimming is
present in the radio nor is any
mixing function active.
This behavior seems to be
influenced by the rotor head
speed.
This indicates to a
vibration problem
which interferes with
the sensors of the
MICROBEAST.
- Check the whole helicopter for
imbalances
- In electric helicopters the motor can
cause high frequent micro-vibra-
tions
- Balance the tail rotor blades very
accurately
- Check the tension of the tail belt
- Choose another mounting position
for the MICROBEAST
- Try other types of gyro pads