75.0127 V3 Jul. 2003 [Rev. 8/13/2004]
Page 8 of 17
RAIN MODE
SNOW MODE
WIZARD SMR
PROGRAMMING
GUIDE – Cont.
RAIN MODE:
1. The Rain Mode is designed to minimize the effect of heavy rain on the Wizard’s auto-learn
requirements. Rain Mode will be enabled after the Wizard goes through two auto-learn cycles
without having a minimum of 6 operating cycles of the door between these 2 auto-learn cycles.
During Rain Mode, auto-learn time will remain the same. However, the second infrared curtain
will change from IR presence detection to IR motion detection. This is done to help eliminate
unwanted detection of heavy rain, as well as it’s effects on the ground. The only required setting
on the Wizard SMR to enable Rain Mode is IR Sensitivity, which must be set to a value of 2
(normal). This mode will automatically expire upon a power reset, or upon expiration of one hour.
This mode could be launched again under the same conditions.
SNOW MODE:
The Snow Mode is designed to minimize the effect of heavy snow on the Wizard’s auto-learn
requirements. Snow Mode may only be enabled by performing the following:
1. Using the BEA remote control, Unlock the Wizard as described in the programming guide.
+ unlock code, if necessary.
2. Set Infrared Sensitivity to LOW (1).
+ 1 = Low Sensitivity
3. Set Auto-Learn Time to 30 seconds (0).
+ 0 = 30 second learn-time
4. Lock The Sensor when complete +
5. After the above changes have been made, the Wizard will go into the Snow Mode after it goes
through 2 auto-learn cycles without having a minimum of 6 operating cycles of the door between
these 2 auto-learn cycles.
6. While in Snow Mode, the auto-learn time will change from 30 seconds to 10 seconds.
This mode will automatically expire upon a power reset, or upon expiration of one hour, as long
as the settings (as outlined above) are in effect. This mode could be launched again under the
same conditions.
DOOR CONTROL
FUNCTION
The Door Control function enables the User
to select a mode of door operation.
1 = Door permanently open.
2 = Door permanently closed – no
detection
3 = Door in automatic mode –
Wizard, upon detection, opens door.
After pressing the DOOR CONTROL
FUNCTION key, the red LED flashes
quickly. After pressing a number
button, the red LED flashes slowly.
3
IR CURTAIN
The IR Curtain function allows the User to
toggle the second IR curtain (farthest from
the door) on & off. When the curtain is off, it
operates in a motion sensing mode.
1 = 1 IR curtain (inner) ON.
2 = Both IR curtains (inner &
outer) ON.
2
After pressing the IR CURTAIN
FUNCTION key, the red LED flashes
quickly. After pressing a number
button, the red LED flashes slowly.
IMPORTANT NOTE:
When changing the values of the above parameters to go from one mode to another, one should
force a set-up by remote control, push buttons, or by a power-off / on sequence.
OBSOLETE
