75.0127 V3 Jul. 2003 [Rev. 8/13/2004]
Page 6 of 17
WIZARD SMR
PROGRAMMING
GUIDE – LOCKING
& UNLOCKING
WIZARD SMR
PROGRAMMING
GUIDE – INQUIRE
ABOUT SETTINGS
WIZARD SMR
PROGRAMMING
GUIDE
All program changes and inquiries can only be accomplished while the Wizard is unlocked.
UNLOCK
LOCK
0-9 0-9 0-9 0-9
Press the UNLOCK key once, then enter
your 4-digit code to unlock the Wizard.
0000
The red LED will flash quickly after
UNLOCK is pressed once. After
entering the valid code, Wizard will
flash red LED slowly.
If access code is set to the factory
default value of 0000, the Wizard will
automatically unlock after the
UNLOCK key is pressed once. The red
LED will immediately begin to slowly
flash red.
When all parameters have been set, press
the LOCK key once. If you wish to enter a
new access code, use the 0-9 number keys
and enter the new 4-digit code within 20
seconds.
If you choose not to enter a new code,
press the LOCK key once more, and the
existing code will be retained. If no key is
pressed within 1 minute, the sensor will lock
with it’s existing code being retained.
0000
After locking, the red LED stops flashing
and the sensor will no longer be in a
program mode.
= Locked with existing code.
0-9 0-9 0-9 0-9
= Locked with new code that is entered.
KEY USER’S ACTIONS DEFAULT LED STATUS
Press the function key that you desire to
inquire about, followed by pressing the
INQUIRY key.
After pressing INQUIRY, count the number
of green LED flashes – this corresponds to
the setting.
EXAMPLE:
After pressing a function button, the
red LED flashes quickly. After pressing
the INQUIRY key, the green LED
flashes the number of the current
setting. No green flash will indicate a
setting of 0.
= 7 = Default sensitivity value
7
Sensitivity alters the sensitivity of the motion
field only. Values range from 0 to 9,
minimum to maximum respectively.
0 = Minimum sensitivity
9 = Maximum sensitivity
After pressing the SENSITIVITY key,
the red LED flashes quickly. After
pressing a number button, the red LED
flashes slowly.
RADAR
SENSITIVITY
CHECK VALUES
RELAY HOLD TIME Relay hold time refers to the hold time on
the output relay of the Wizard. Values range
from 0 to 9, .5 seconds to 9 seconds
respectively.
0 = .5 secs.
1 = 1 sec. to 9 = 9 seconds. 1
through 9 in 1 second increments.
0
After pressing the RELAY HOLD TIME
key, the red LED flashes quickly. After
pressing a number button, the red LED
flashes slowly.
KEY USER’S ACTIONS DEFAULT LED STATUS
OBSOLETE
