BDCOM S6508 Switch Hardware Installation Guide
Figure 2-1 the right way of moving the chassis
The right way is the following: With a person standing at each side of the chassis,
grasp the chassis handle with one hand, and use the other hand near the back of the
chassis for balance. Slowly lift the chassis in unison. Move and keep balance.
2.1.3 Safety principal of operation with electricity
Please check the operating room carefully such as Power Gounding is OK, the
floor is dry. Confirm that there is no hazards.
Before install, Must know the location of the room’s Power switch.
Do not maintenance the S6508 with power on by one person alone.
Do not place the chassis in the wet room, also do not allow the liquid inpour the
chassis.
When using DC-Power to supply, follow the guide to connect the wire.
2.1.4 Preventing Electrostatic Discharge Damage
Electrostatic discharge(ESD) damage,
which can occur when electronic cards or
components are improperly handled. This can cause serious damage to the system.
Follow these guidelines for preventing ESD damage:
1)
The chassis and the floor have proper gounding.
2)
Keep the air clean.
3)
Maintain the humidity within an acceptable range.
4)
Always use an ESD wrist, and ensure that it makes maximum contact
with the skin.Make sure that the wrist is in contact with bare skin.
- 23 -
