18
Ovi-Scan
6 Ovi-Scan console
The Ovi-Scan console can be used as a stand alone video monitor. If the console is switched on without
the Duo-Scan attached, it will automatically switch into ‘VIDEO MONITOR’ mode. In this mode, the
displayed video input can be changed by pressing the buttons on the tally controller.
Note: To switch the console on without a Duo-Scan attached, press buttons 1, 2 or 3 on the attached
tally controller.
Button 1:
Pressing button 1 on the tally controller will select the external video input (connector ‘M’) on the rear
panel of the console.
Button 2:
Pressing button 2 on the tally controller will select the RF video input. The console defaults to RF
channel 1 and each subsequent press will cycle through the 4 available channels.
The selected RF channel is fed out through the ‘ExT VID’ connector ‘N’.
Button 3:
Pressing button 3 on the tally controller will select the digital video input, this is the input used
by the Duo-Scan. This allows the Duo-Scan output to be viewed on the console even if correct
communications have not been established.
Button 0:
Pressing button ‘0’ on the tally controller will put the console into low-power standby mode.
Brightness/Contrast control
The brightness and contrast in video mode can be adjusted as follows:
Pressing ‘1’ & ‘2’ on the tally increases the selected parameter.
Pressing ‘3’ & ‘0’ on the tally decreases the selected parameter.
Pressing ‘2’ & ‘3’ on the tally switches between brightness and contrast.
Ovi-Scan manual v.3.indd 18
13/07/2012 16:44