13
2.2.6 Drafting menu
DRAFTING
TALLY 0
DELAY
100
The drafting menu is used to configure the switching of the drafting outputs, each tally value
(0, 1, 2, 3, 4 and late) has separate settings for delay, and 4 gates.
A: Selecting TALLY
Pressing soft key 2 cycles through the tally values in the following sequence; ‘0’, ‘1’, ‘2’, ‘3’, ‘4’
and ‘LATE’.
B: Select DELAY or GATE
Pressing soft key 3 cycles through the delay and gate options in the following sequence:
‘DELAy’, ‘GATE 1’, ‘GATE 2’, ‘GATE 3’, ‘GATE 4’.
C: Set up DELAY time or GATE settings
Pressing soft key 4 cycles through the available values for the option selected in column 3.
If ‘DELAy’ is selected, then pressing soft key 4 will cycle through delays of 100 mS, 300 mS and
500 mS.
If one of the gates is selected then pressing soft key 4 will cycle through the gate options (‘ON’, ‘OFF’
or ‘DISABLED’).
Example:
To set up tally 1 for a 300 mS delay with gate 1 on, gate 2 off.
Press soft key 1 until the drafting menu is visible.
Press soft key 2 until ‘TALLy 1’ is visible in the 2nd column.
Press soft key 3 until ‘DELAy’ is visible in the 3rd column.
Press soft key 4 until ‘300’ is visible in the 4th column.
Press soft key 3 until ‘GATE 1’ is visible in the 3rd column.
Press soft key 4 until ‘ON’ is visible in the 4th column.
Press soft key 3 until ‘GATE 2’ is visible in the 3rd column.
Press soft key 4 until ‘OFF’ is visible in the 4th column.
Note: The drafting settings are stored in the system even when power is removed.
The switched outputs are accessed via the ‘DRAFTING’ connector ‘Q’
Ovi-Scan manual v.3.indd 13
13/07/2012 16:44