BayTech Telplex TX102, Owner'S Manual

Page: 70 / 99

64
64
If you wish to change the baud rate for the composite port to 38,400 bps,
enter "D" in response to the prompt and the Telplex will respond with the
reconfigured status of the port, the option menu, and the prompt as
follows:
+------+------+------+------+------+--------+
| Port | Baud | Word | Stop |Parity| Line |
| | Rate | Size | Bits | | Type |
+------+------+------+------+------+--------+
| 5 | 38400| 8 | 1 | None | Direct |
+------+------+------+------+------+--------+
Exit/Save......1
Set Baud Rate..2
Line Type......3
Enter Request:
If you wish to change the Line Type of the Telplex, type "3" in response to
the prompt. The Telplex will respond with:
1 For Modem
2 For Direct
Enter Request or X to Exit :
Enter the number corresponding to the desired Line Type.
IMPORTANT: If you intend to connect an external modem to the
composite port, you must choose Modem Line Type. If you choose
Modem Line Type, keep in mind this does not configure the external
modem to communicate with a dial or leased line. If you intend to
connect the Telplex via cable, you must choose
Direct Line Type.
If the baud rate and/or Line Type is acceptable, type "X" (Exit/Save) and
the Telplex will respond with:
Save Baud Rate Changes Permanently ? (Y/N):
If you enter "Y", the new baud rate for the composite port will be stored
permanently in non-volatile memory and the Telplex will subsequently
power up at that configuration. If you enter "N", the new baud rate will be
stored in RAM and on the next power-up, the Telplex will revert to the
previous configuration.