28
Note: There are many different models and brands of Bill Acceptors that are used on redemption games.
Your Bill Acceptor may differ from the unit shown. A “Upstacker” should be used for clearance issues.
Standard DBA is MEI # AE2431-D5E Part # A5AC9091
Determine if Bill Acceptor has power:
Turn game ON—The bill acceptor should make noise as stacker cycles and green lights on outside bezel
should flash.
If NO power: Use meter to measure 110 AC voltage at cable going into Bill Acceptor from power strip.
If power is OK: Clean Bill Acceptor path to make sure there is nothing jamming unit. Check dipswitch settings
on side of acceptor.
Make sure switch # 8 is OFF for
Always Enable
ERROR CODES
Count the number of flashes on front bezel
of Bill Acceptor and follow chart for repair
BILL ACCEPTOR DIAGNOSTICS
POWER SUPPLY DIAGNOSTICS
1.) Verify AC power to game. Check power strip in front door. The rocker switch should be illuminated.
2.) Check connection to power supply.
3.) Ensure Power Supply switch is set to 115V (or 230V)
(
Some model power
supplies may not have this)
4.) Ensure Power switch is on.
5.) Ensure fan is turning.
- If power supply fan is turning and there is no 12 Volt out:
Check power supply cables to the Power Distribution Board.
This board takes the power in, and directs it to the different 12 volt loads.
Unplug all power out connectors from the top of the Power Distribution Board.
Turn on game and if it boots correctly, plug one cable in at a time until the issue
is found.
Replace power supply if this board is not receiving 12 volts. (A5PS1013)
POWER DISTRIBUTION
BOARD AACB5156
