Bay Networks Centillion 5000 5000BH, Using Manual, Page: 40 / 70

Using the 8-port TokenSpeed and TokenSpeed/MCP Switch Modules
3-12 893-01019-A
Replacing a TokenSpeed/MCP Module
To replace a TokenSpeed/MCP module in a chassis, follow these steps:
1.
Notify network users that the network will be out of service, and advise
them to save all work and log out of active sessions.
2.
Save the current configuration in a file on your SpeedView management
station.
For instructions on saving configuration files, refer to Using SpeedView 2.1
for Windows.
If you have an extra Centillion switch chassis, you can minimize network
disruption by loading the saved configuration on the new TokenSpeed/MCP
module using the additional chassis; then replace the old module.
3.
Turn off the power to the switch.
4.
Loosen the two retaining screws on the module until they pop free of the
switch chassis frame (see
Figure 3-9 ).
5.
Rotate the left and right inserter/extractor levers away from the center of
the module to loosen the module from the backplane connectors (see
Figure 3-9 ).
Figure 3-9. Loosening the TokenSpeed module
Caution: You should not hot swap a TokenSpeed/MCP module.
6470
TKNSPD.BK Page 12 Thursday, July 17, 1997 11:43 AM