Bay Networks Centillion 5000 5000BH, Using Manual, Page: 37 / 70

Installing and Connecting the TokenSpeed Module
893-01019-A 3-9
• Port 2:
— Act LED lights when software is loaded from flash memory.
— Ins LED lights when software loading is complete and the system begins
executing.
• All LEDs turn off when the module has started up successfully.
• Ins LEDs on all ports toggle on and off, until the first port inserts successfully.
On the TokenSpeed module, the following sequence occurs:
• Port 1:
— Act (activity) LED lights during switch memory test.
— Ins (inserted) LED lights during management bus test.
• Port 2:
— Act LED lights while the module waits for software download from the
MCP.
• All LEDs turn off when the module has started up successfully.
• Ins LEDs on all ports toggle on and off until the first port inserts successfully.
Configuring the TokenSpeed Module
The TokenSpeed module is shipped preconfigured with the configuration settings
listed in
Table 3-3 . If transparent switching and no spanning tree operation are
appropriate for your network, no further configuration is necessary.
Table 3-3. Factory default configuration settings
Parameter Factory default Possible settings
Switching mode Transparent Transparent, Source Route,
Source Route Transparent
Spanning Tree Protocol None None, IEEE, IBM
State Enabled Enabled, Disabled
Port type Station Station, Hub, Bay/SNPX RO,
RI–other, RO–other
Ring speed 16 Mb/s 16, 4, Auto
Speed sense Disabled Disabled, Enabled
TKNSPD.BK Page 9 Thursday, July 17, 1997 11:43 AM