Baxi Luna 3 Comfort, Installers And Users Instructions

Page: 44 / 288

44
926.427.1 - GB instructions pertaininG to the user
3.4 room and domestic hot Water (d.h.W.) temperature adjustment
The room ( ) and D.H.W. ( ) temperature adjustment are carried out by pressing the relative
+/-
buttons (figure 1).
When the burner is lighted the display shows the symbol ( ) as described in section 3.1.
central heating (ch)
During a CH mode, the display shows a CH ( ) symbol and the room temperature value (°C).
During a temperature regulation, the display shows “ aMB ”.
DoMestic hot Water (D.h.W.)
During a D.H.W. request, the display shows a D.H.W. ( ) symbol and the room temperature value (°C).
During a temperature regulation, the display shows “ hW sp ”.
NOTe:
if an external water tank is connected to the gas boiler, during a domestic hot water request, the display shows a
( ) symbol and the room temperature value (°C).
3.4.1. remote control installed on the boiler front panel
If the remote control is installed on the boiler front panel, the
+/-
buttons regulate the Central Heating flow temperature.
The display shows the room temperature.
settinG the Date-tiMe
Press the
ip
button: the display shows (briefly) the message
proGr
and the time starts flashing.
Note: If no button is pressed the function ends automatically after approx. 1 minute.
• Use the buttons +/- to set the hour;
• Press the OK button;
• Use the buttons
+/- to set the minutes;
• Press the OK button;
• Use the buttons
+/-
to set the day of the week “
Day
”
(1…7 corresponding to Monday…Sunday);
Press the ip button to exit DATE-TIME setting.
3.5 programming (progr)
To enable the function, press the button (the display shows the symbol)
Time period programming allows the setting of boiler automatic operation in heating mode in fixed time slots and
on fixed days of the week.
Boiler operation settings can be made for
single days or groups of consecutive days.
3.6.1. single days
Four time bands (4 boiler activation and deactivation periods in heating mode even with different times from day to
day) are available for every day selected, as shown in the following table:
3.6 programming heating mode operation times