ELECTRODE LEAD,RESISTOR OR SPARK GENERATOR
To replace any of these components it is necessary
to gain access to the inside of the lamp box.
The lamp box, which is clipped at the top and
hinged at the bottom is rotated forward to lay flat.
Use the handles provided.
Remove the bulbs.
Remove the two screws that secure the top half of the
lamp box in place and bring it forward to expose the
spark generator and resistor.
To change the electrode lead :-
Remove the spade connector that is attached to the
spark generator and the spade connector that is
connected to the electrode.
Remove the lead and its sheathing from the retention
clips.
On entering the lamp box, the sheathing goes
through a grommet. The grommet can be removed
and the sheathing brought clear of the fire with it.
The old electrode lead is now withdrawn from the
sheathing and replaced by the new one.
Fix the spade connector to the electrode and re-route
the sheathing back to the lamp box, securing it in the
clips from which it was previously removed. Refit the
grommet and fix the spade connector to the spark
generator. Replace the lamp box top.
To change the resistor :-
Note which terminals the resistor leads are connected
to.
Disconnect the resistor leads from the terminals and
pull the resistor out of the clip that retains it.
Refit the new resistor in the reverse order from which
the old one was removed. Replace the lamp box top.
To change the spark generator :-
Disconnect the electrode lead and the electrical
wiring from the spark generator.
Remove the two screws that secure the spark
generator and use them to secure the new one in
place.
Reconnect the electrical wiring and the electrode
lead. Replace the lamp box top.
Rotate Lamp Box
Forward Using
The Handles
Handle
Electrode Lead
Sheathing
Sheathing
Electrode Lead
Grommet
Spark
Generator
Resistor
Lamp
Holder
Spark
Generator
Resistor
Lamp
Holder
30
