Page 40
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2007.
17.10 To replace the burner.
(See figure 41).
1.
Remove the burner unit (See section 17.5).
2.
Support the elbow injector and unscrew the
injector nut.
3.
Remove the two screws from the burner clamping
plate (See figure 41)
4.
Lift the right hand side of the burner, slide it to the
right and lift clear
5.
Refit in reverse order.
17.11 To remove the main burner injector.
(See figure 42).
1.
Remove the burner (See section 17.8).
2.
Remove the burner clamping screw (See figure
42)
3.
Unscrew the injector from the burner
4.
Refit in the reverse order.
17.12 To remove the appliance from the fireplace.
1.
Remove the burner unit - See section 17.5.
2.
If the fire retention is as method 1 (See section 9.1
of installation instructions), remove the screws.
If the fire retention is as method 2 (See section 9.2
of this guide), slacken the hexagonal adjusters on the
cable adjusters and unscrew the thumb screw to
release the cables.
3.
Refit as described in the relevant installation sections. Make sure gas soundness,
sealing, spillage test and performance are satisfactory.
Figure 42. Main burner
injector removal
Figure 41. Removal of burner
