Page 10
DTL-960e Single Channel Colour Digital Video Recorder
User Manual
REAR PANEL CONNECTIONS
SCSI Port
The unit is equipped with a SCSI port for connecting external archive devices. The unit only supports a single SCSI device.
The SCSI ID must be set to 0 and the SCSI bus must be terminated, otherwise the system will not operate correctly.
Audio In/Out
The unit is equipped with a mono audio input and output for the recording and playback of sound.
, Video Input and Output
The unit is equipped with both SVHS (Y/C separated video signal) and Composite inputs and outputs. The video inputs
are auto-terminating.
The SVHS input is Active Looping, and will only loop while the unit is on.
Do not connect both video inputs at the same time.
RS-232 Serial Port
The RS-232 Serial Port is provided for software upgrades, and for external control of the unit. Use a Null Modem cable
when connecting to a PC.
When connecting to a multiplexer, it may be necessary to construct a cable using the pin-out documentation of the MUX
as a guide. See the pin-out configuration for the DTL-960e below.
Connector
50 Pin, High Density SCSI-2
Gender (on unit)
Female
Compatible devices
DAT, AIT, CD-R, CD-RW
Autoloader Support?
Yes
SCSI ID
0
Connector Type
DB9
Gender (on unit)
Male
Cable Required (Connected to PC)
Null Modem
Cable Required (Connected to Multiplexer)
Variable, depending on pin-out configuration of MUX
Pin
Use
1
DCD
2
RX
3
TX
4
Not connected
5
Ground
6
Not connected
7
RTS
8
CTS
9
Not connected
Figure 5 - DB-9 Pin Configuration
For RS-232 Serial Port
1
5
6
9
SVHS Input
4-pin Mini-DIN connector
SVHS Output
4-pin Mini-DIN connector
SVHS Looping
Only while unit is On
Composite Input
75 Ohm BNC connector
Composite Output
75 Ohm BNC connector
Composite Looping
Yes, while unit is On or Off
All manuals and user guides at all-guides.com
