Operating Manual for
BAUER Plug & Play Separator System
11
4
SETUP OF THE PLUG & PLAY SEPARATOR SYSTEM
Condition of the BAUER Plug & Play Separator System upon Delivery
The BAUER Plug & Play Separator System was developed by BAUER GmbH. It is delivered as a complete
unit (separator, feed and discharge pumps, incl. pipelines and control).
You must connect the switch cabinet to the electrical supply. Connecting the system to the feed or clear
flow line using the supplied hoses, if included, completes the installation of the Plug & Play Separator Sys-
tem.
DANGER
Work on electrical and electronic components of the system may only be performed
by a trained electrician or otherwise appropriately trained personnel under the guid-
ance and supervision of a trained electrician in accordance with the applicable elec-
trical and electronic regulations.
Required Tools
Special tools are not required for setting up the Plug & Play Separator System.
Standard assembly and electrical tools are required for assembly, setup and disassembly.
Transport
Improper transport could cause the device to fall or tip. Severe injuries could result!
The customer must check based on the dimensions and weight of the Plug & Play Separator System whether
the available lifting equipment (forklift or crane, with corresponding belts or chains) is sufficient for setting up
the Plug & Play Separator System.
The Plug & Play Separator System may only be lifted as follows:
By forklift: At the provided lifting points (2x) for forklift forks
The following points must also be taken into account:
The feed pump and discharge pump as well as all lines should be pumped empty.
Move the slide plate to the transport position (vertical)
The transporter must ensure that the BAUER Plug & Play System is tied down properly.
Slide plate
WARNING
Lifting points for forklift
WARNING
Figure 3 Transport aids
