Basler BE1-59N, Instruction Manual

Page: 35 / 39

9171400990 Rev G BE1-59N Testing 5-1
SECTION 5
•
TESTING
INTRODUCTION
The following procedures verify proper relay operation and calibration.
Results obtained from these procedures may no fall within specified tolerances. When evaluating results,
consider three prominent factors:
•
Test equipment accuracy
•
Testing method
•
External test set components tolerance level
OPERATIONAL TEST
Step 1. Perform test setup (Figure 5-1) and apply power to the relay. Verify that the POWER LED is
ON, and that the power supply status contact is open.
Figure 5-1. Typical Test Setup
Step 2. Set all TIME DIALS (if any) to the zero position.