- 56 -
Attaching the drip tray
•
The drip tray is used to collect liquids which
may flow out through the front door of the
combi steamer. Place the tray in front of the
combi steamer and fasten it with screws found
in a bag provided in the package. The screws
are screwed into the threaded inserts in the
lower front part of the combi steamer (Figure
on the right).
Attaching the drip tray drain
•
Fit a plastic closure and a white water drain
hose which is found in the package. Make
sure that the hose is installed and fixed in
such a way as to allow the water to properly
drain from the drip tray to the sewage
network (Figure on the right).
5.1.5
Power supply connection
DANGER! Electric shock hazard!
In the case of improper installation the device may cause injuries!
Before the installation compare the local power grid parameters with the
parameters of the combi steamer power supply (see the nameplate). The
device can be powered only when these data are consistent!
•
Before connecting to the power grid, make sure that the voltage and frequency
indicated on the nameplate correspond with those of the local power grid.
The allowable deviation in voltage is ± 10%.
•
When the device does not have wheels to facilitate its movement we recommend to
connect the device to the power supply first, and then position it in its workplace.
•
Make sure the power cord does not get damaged when moving the combi steamer.
This way the combi steamer will be connected to the power supply without difficulty
and in a more safety manner. The power cord shall be placed so that it does not
reach the ambient temperature higher than 50 °C at no point.
