BARTINGTON INSTRUMENTS
DCN1040
Page 14 of 39 OM3100/2
6.3.3 External Power
The unit can be powered by an external battery to be connected to the unit if the internal
batteries become exhausted. This is currently under development.
6.4.Fuses
For safety reasons, the battery (comprising four separate assemblies) has four internal fuses.
These are not customer replaceable and in the event of the fuses blowing, the device must be
returned to Bartington Instruments for repair.
7. Installation of the Grad-13
7.1. Unpacking
Safe handling precautions must be observed.
7.2. Orientation
The directions of the sensor axes are marked on the label at the connector end.
7.3. Mounting
The sensor assembly is mounted in a stress free manner within the outer protective tube.
Note:
Ensure that the Grad-13 enclosure is not excessively stressed, as the alignment of
the sensors may be affected or the assembly integrity may be compromised allowing the
ingress of foreign matter.
Note:
See drawings DR3344 and DR3286
on the product webpage.
