Baroness SP160EB, Owner'S Operating Manual

Page: 70 / 83

Rear Tires
Follow the steps below to remove the rear
tires:
Loosen the bolts.
1
lp4z4o-002
Rear Tires_001
1 Bolt
Securely place the jack beneath the jack-up
point of the rear left/right frame area, and
then raise it until the tire lifts off the ground.
"Jack-Up Points" (Page 5-6)
Remove the bolts.
Remove the tire from the wheel mounting
seat.
Important
Tighten the bolts in the tightening order
(crosswise).
For installing the rear tires, reverse the
removing procedure.
Adjustment of Steering Chain
Excessive play with a loose steering chain may
stretch the chain further while you may feel a
heavy steering wheel with an excessively tight
chain and the chain and wheel may wear
prematurely.
Important
Make sure that the steering chain has the
specified amount of slack.
Open the front cover.
1.
2.
3.
4.
1.
With the nuts on each end of the steering
chain, adjust the chain tension so that there
is approximately 5 mm (0.20 in) of slack.
1
A
3
4
2
2
y7bwwh-001
Adjustment of Steering Chain_001
1 Steering chain
2 Nut
3 Front wheel arm
4 Adjustment screw
A 5 mm (0.20 in)
After making adjustments, firmly secure the
nuts.
Adjustment of Traveling Pedal
Important
Do not adjust the traveling pedal.
Traveling at 15.0 km/h or more will damage
the machine.
The traveling pedal is set a factory default
forward speed of 15.0 km/h and reverse speed
of 5.0 km/h.
2.
3.
SP160EB
Maintenance
Page 5-14
Maintenance Work