Baroness LM56GC, Owner'S Operating Manual

Page: 82 / 88

Overlap Marks
Do the cam bush and cutter pin rattle considerably?
Is the spring pressure for the adjustment nut too light?
NO
Adjustment of spring compression length
(See "Adjustment of Cutter Adjustment Spring".)
After loosening blade engagement, streaks still appear.
Has the bed knife (bottom blade) become curved?
NO
Is the sliding of the cam bush and frame extremely
rough?
YES
࣭
Back lapping
࣭
Surface grinding of bed knife (bottom blade)
࣭
Replacement of bed knife (bottom blade)
NO
YES
Does the reel cutter (cutting cylinder) move sideways?
࣭
NO
YES
Is the reel bearing outer ring driven in at an angle?
Loosening of blade engagement
࣭
Replacement of cam bush
࣭
Replacement of cutter pin
࣭
Replacement of cam bush
࣭
Replacement of frame
࣭
Correctly driving in the outer ring
࣭
Replacement of reel bearing
NO
YES
Do the cam bush and frame rattle?
YES
Clean and lightly apply grease to make sliding smoother,
and then reassemble.
YES
NO
NO
NO
YES
NO
Is the reel bearing malfunctioning?
<Important>
࣭
Replacement of reel bearing (Replace every year.)
YES
Checking proper tightening of bearing on reel
cutter (cutting cylinder)
(See "Attaching Reel Cutter (Cutting Cylinder)".)
Profusely apply grease to the reel bearing before installing
it. Replace the oil seal at the same time.
<Important>
For replacing the frames, contact your
sales representative or dealer.
or58dr-003E
Overlap Marks_001
LM56GC
・
LM66GC / LM66TC
Maintenance
Page 5-26
Troubleshooting Procedures of Aftercut Appearance