Baroness LM56GC, Owner'S Operating Manual

Page: 79 / 88

Insert a thickness gauge (accessory tool)
between the engine clutch and the clutch
facing.
Make adjustment of the engine position
so that the front and rear clearances will
be the same distance, and then tighten
the bolts A.
1
3
2
wdzf6u-006
Adjustment of Engine Clutch_002
1 Engine
2 Bolt A
3 Bolt B
Adjustment of Clutch Wire
Important
Make sure that the wire is not cracked or
damaged.
If the wire is cracked or damaged, replace it
with a new one immediately.
Important
Due to frequent use, movement of the lever
will become dull, play of the inner wire will
change and the inner wire will be stretched
depending on R angle of the outer wire.
Inspect them and, if necessary, implement
adjustment.
Make adjustment of the clutch wire so that
the operation distance of the clutch plate
between "ON" and "OFF" positions of the
main clutch lever will be 1.0 - 2.0 mm
(0.039 - 0.079 in).
Loosen the clutch wire adjusting nuts.
Adjust the operation distance of the
clutch plate by changing the clutch wire
position.
2.
1.
2.
After appropriate adjustment of the
operation distance of the clutch plate
completed, tighten the clutch wire
adjusting nuts.
1
3
2
A
4
5
wdzf6u-007
Adjustment of Clutch Wire_001
1 Engine clutch
2 Clutch plate
3 Clutch facing
4 Clutch wire adjusting nut
5 Clutch wire
A 1.0 - 2.0 mm (0.039 - 0.079 in)
Adjustment of Clutch Spring
The factory default setting of the clutch
spring total length is 63.0 mm (2.48 in).
The longer the spring is set, the lighter
clutch handling is provided. The shorter, the
heavier.
Make adjustment with the spring
adjustment nut so that the total length of
the clutch spring will be 63.0 mm (2.48
in) when the main clutch lever set to the
"ON" position.
Loosen the lock nut and adjust the clutch
spring total length with the spring
adjustment nut.
Confirm that there is no engine clutch
slipping when the main clutch lever set to
the "ON" position.
3.
1.
2.
3.
Maintenance
LM56GC
・
LM66GC / LM66TC
Maintenance
Page 5-23
Maintenance Work