Baroness LM56GC, Owner'S Operating Manual

Page: 74 / 88

Remove the fulcrum seat bolt used to
temporarily install the bed knife base arm.
Note:
With the weight of the bed knife base arm,
the bed knife (bottom blade) will slightly
come into contact with the reel cutter
(cutting cylinder).
Align the punch mark on each (left and
right) cam bush with the travel direction.
1
kx7caa-004
Installing The Bed Knife Base_004
1 Punch mark
Make sure that the bed knife (bottom blade)
contacts the reel cutter (cutting cylinder).
1 1
2
2
A B
kx7caa-005
Installing The Bed Knife Base_005
1 Reel cutter (Cutting cylinder)
2 Bed knife (bottom blade)
A Gap
B No gap
6.
7.
8.
Insert one or two strips of newspaper into
the space between the reel cutter (cutting
cylinder) and the bed knife (bottom blade)
at an angle of 90 degrees. Then, rotate the
reel cutter (cutting cylinder)
counterclockwise (as seen from the left side
of the mower unit) by hand to check the
sharpness of the entire range (three or four
points) of the reel cutter (cutting cylinder).
1
2
kx7caa-006
Installing The Bed Knife Base_006
1 Reel cutter (Cutting cylinder)
2 Bed knife (bottom blade)
Adjust the positions of the cam bushes so
that both sides cut.
"Adjusting CAM" (Page 5-9)
Note:
After making adjustments, use a marker,
etc., to place a mark on the frame at the
position of the punch mark.
kx7caa-007
Installing The Bed Knife Base_007
9.
10.
LM56GC
・
LM66GC / LM66TC
Maintenance
Page 5-18
Maintenance Work