Baroness LM56GC, Owner'S Operating Manual

Page: 42 / 88

1 Cutting height gauge
2 Small screw for cutting height setup
3 Fly nut
4 Front roller
5 Drum
6 Bed knife (bottom blade)
7 Reel cutter (Cutting cylinder)
8 Dethatching blade
9 Small screw for groomer setup
A Cutting height
B Groomer height
Follow the same steps to adjust the groomer
height on the opposite side.
Firmly tighten the nuts that secure the left
and right groomer adjustment screws.
Tighten left and right special nut A.
Again, make sure that the groomer height is
at the required position by positioning the
cutting height gauge against the front roller
and drum at the edge on the left and right
sides of the mower unit.
6 1
2
5
4
3
2qrq2r-003
Adjustment of Groomer_004
1 Groomer adjustment screw
2 Nut
3 Special nut A
4 Special nut B
5 Spring
6 Front groomer
Note:
In the case that the front groomer is not
used, you do not have to change the set
groomer height.
Loosen the nuts fixing the right and left
groomer adjustment screws, lift the groomer
and tighten the right and left nuts to raise the
front groomer so that it cannot contact the
lawn.
6.
7.
8.
9.
Next time the groomer is used, loosen the
right and left nuts, lower the groomer and
tighten the nuts so that it can return to the
groomer height set previously.
Procedure to Start/Stop Engine
Start/Stop of Engine
Procedure to Start Engine
Caution
Before starting the engine, make sure that
there are no other people or obstacles around
the machine.
Caution
Make sure that the engine clutch cover is
installed in the prescribed position.
Make sure that the engine switch is in the
"OFF" position.
B A
1
v2e27i-035
Procedure to Start Engine_001
1 Engine switch
A ON
B OFF
Make sure that the brake is locked.
2 1
A
B
ud9f2u-004
Procedure to Start Engine_002
1.
2.
LM56GC
・
LM66GC / LM66TC
Handling Instructions
Page 4-18
Procedure to Start/Stop Engine