Bardac E3 Series, User Manual

Page: 48 / 62

48
| E3 IP66 Outdoor Rated User Guide |
Version 1.25 www.bardac.com
Bit Function When “0” Function When “1”
15
In the event of a trip, the associated code
is shown in this byte
14
13
12
11
10
9
8
7
6
Not Ready Drive Ready
5
4
3
2
- Drive In Standby Mode
1
Drive OK Drive Tripped
0
Drive Stopped Drive Running
Bit 6: Drive Ready to Run is defined as:
 Not tripped.
 Hardware enable signal present (DI1 ON).
 No mains loss condition.
8.4.2. Register 2001 definition – New Status Word
Bit Definition Description
0
Ready This bit is set if no trip and no mains loss, plus hardware enabled
1
Running This bit is set when drive is running
2
Tripped This bit is set when drive is under trip condition
3
Standby This bit is set when drive is in standby mode
4
Fire Mode This bit is set if fire mode is active
5
Reserved Read as 0
6
Speed Set-point Reached (At Speed) This bit is set when drive is enabled and reaches speed set point
7
Below Minimum Speed This bit is set when drive is enabled and speed less than P-02
8
Overload This bit is set if motor current > P-08
9
Mains Loss This bit is set if mains loss condition happens
10
Heatsink > 85°C This bit is set if drive heatsink temperature over 85°C
11
Control Board > 80°C This bit is set if control PCB temperature over 80°C
12
Switching Frequency Reduction This bit is set if PWM switching frequency foldback is active
13
Reverse Rotation This bit is set when motor is in reverse rotation (negative speed)
14
Reserved Read as 0
15
Live Toggle Bit This bit will toggle each time this register is read
8.4.3. Register 2005 definition – IO Status Word
Bit Definition Description
0
DI1 Status This bit is set when digital input 1 is closed
1
DI2 Status This bit is set when digital input 2 is closed
Modbus R
TU Communications
8