Barco X8, Installation Manual

Page: 49 / 96

7. Basic setup procedures
7.4 Installing the X8 rental tile
Necessary tools
No tools.
How to install the X8 rental tile in to the LED-wall?
1. Check if all locking mechanisms of the X8 rental tile are open:
- the two clamps at the top of the rental tile must be open.
- the clamp at the right side of the rental tile (seen from the rear of the rental tile) must be open.
- the two retractable pins at the right side of the rental tile (seen from the rear of the rental tile) be must be retracted.
- the two lock handles at the left side of the rental tile (seen from the rear of the rental tile) must be pulled out completely.
- the two lock handles at the bottom of the rental tile (seen from the rear of the rental tile) must be pulled out completely.
3
1
1
1
2
2
3
3
3
3
1
2
Image 7-5
2. Check if all locking mechanisms are open on the free edges of the installed rental tiles (edges that will join the rental tile to install).
3. Is this a hanging X8 rental display?
If yes, Gently approach the LED-wall with the rental tile and push the rental tile upwards with its mounting pins into the mounting
holes of the upper rental tile.
As a result the locking handles at the bottom of the upper fi xed rental tile latches and capture the mounting pins of the lower
rental tile.
If no, Gently place and align the rental tile on top of the lower rental tile.
As a result the locking handles at the bottom of the rental tile latches and capture the mounting pins of the lower fi xed rental tile.
4. Fasten the two lock handles at the horizontal adjoining edge. Push the handle inwards and turn quarter turn clockwise (reference
1 image 7-6).
5. Fasten the two clamps at the horizontal adjoining edge (reference 2 image 7-6).
R5905160 X8 RENTAL DISPLAY 25/02/2013 45