Barco VRWF-3200, System Installation Manual

Page: 49 / 71

9. Getting started
9. GETTING STARTED
Overview
• Start up
• Projector shutdown
• Full system shutdown
• source selection
9.1 Start up
C
AUTION
:
In case the VR Workroom system is connected to an external control interface i.e. via RS232, it is
only allowed to control it with the ON/OFF commands (starting up and shutting down the projectors ).
No other sets of commands will be used. Using other commands than ON/OFF will not guarantee proper
functioning of the VR Workroom system !
2 start up methods
There are 2 ways to start up the system :
• Start up using the Keyboard : this is the recommended method
• Start up using the Remote Control Unit (RCU)
How to power up the projector ?
1. On the slave projector, switch the power switch to “1” (image 9-1)
L3 and L1 light up red. After the initialization period L1 goes off. (image 9-2, image 9-3)
2. Do the same on the Master projector
Image 9-1
Image 9-2
Image 9-3
Standby state : L3 is red
R5976989 BARCO VR WORKROOM 22/09/2006 43