Barco R92112071, User Manual

Page: 81 / 184

7. Advanced
How to select an Edit Mode ?
1. When the Edit dialog box is displayed, the Select mode is selected by default.
2. To go to the next mode (go to the right) press ENTER .
3. To return to a previous mode (go to the left) use BACK
7.5.6.4 Editing a geometry fi le
Introduction
The following procedures are written for a 2x2 mode adjustment. This adjustment involves the adjustment of the 4 corner points of
the image. This is a level 1 adjustment and will affect the whole image.
The adjustment procedure is similar for all the modes. The only thing to keep in mind is the order in which the points will be adjusted
i.e. always start with the lowest level points and end with the highest level zones (see
Geometry distortions/level hierarchy
) .
A 3x3 mode adjustment gives the following new points to be adjusted ( the 4 points of the 2x2 mode being already adjusted : they
are therefore left out of the grid). Note that in this mode, 2 levels are involved, the level 2 and the level 3 .
A 5x5 mode adjustment gives the following new points to be adjusted. Note that in this mode 3 levels are involved, level 4, 5 and
level 6 (previous adjusted points are left out).
...
How to start up the geometry edit ?
1. Start up the Geometry Edit menu
2. Press ↓ to select 2x2...
3. Press ENTER
A dialog box is displayed. The Select mode is enabled and the top/left (row = 0 ; colom = 0) corner is selected
Image 7-44
How to select another point ?
1. Press → to select the next adjustment point
R59770198 BARCO SIM 7D 13/02/2013 77