3-1
Power Connections
5975948 RETRODATA 2100 260898
3
POWER CONNECTIONS
AC Power cord connection
Power cord connection
Fuses
Projector Status LED
Switching On / To Stand-By / Off
Lamp Life
Fuses
Warning
For continued protection against fire hazard :
- replace with the same type of fuse.
- refer replacement to qualified service personnel
Fuse type : T16AH/250V
Order no. : B370076
AC Power (mains) Cord Connection
$8',2287
$8',2,1&
$8',2,1%
$8',2,1$
9,'(2
9,'(2
69,'(2
5*%+&9
5*%+&9
/5
/5
/5
/5
,5
5
5
*
*
%
%
+&
+&
9
9
72/2&$/&2175 2/21/<
3257
3257
3257
3257
3257
56,1 56287 &2003257 &75/
hard wire remote
2KP:
/5
Internal mains connection
permanently connected
Internal power switch always to be
positioned in the
’1’
(ON) state
Ensure that the power switch is in the 'on-1' position on the rear
control panel and also ensure the internal mains power plug is in
place. The projector will not activate unless these two conditions are
correctly undertaken.
Power cord connection
P O W E R / M A I N S
POWER CONNECTIONS
AC Power cord connection
Power cord connection
Fuses
Projector Status LED
Switching On / To Stand-By / Off
Lamp Life
Fuses
Warning
For continued protection against fire hazard :
- replace with the same type of fuse.
- refer replacement to qualified service personnel
Fuse type : T16AH/250V
Order no. : B370076
AC Power (mains) Cord Connection
Ensure that the power switch is in the 'on-1' position on the rear
control panel and also ensure the internal mains power plug is in
place. The projector will not activate unless these two conditions are
correctly undertaken.
Warning !
Verify the power voltage corresponds to that of the wall outlet.
Art. No. R9001300
must be connected to a
120V/230 V
AC power
source. The projector input voltage is internally switchable between
120V/230V AC and is adjusted to 230V AC on leaving the factory
If the wall outlet voltage is different, call a qualified technician for
power adaptation of the projector.
Power (mains) cord connection
Use the delivered power cord to connect your projector to the wall
outlet. Plug the female power connector into the male connector at
the rear of the retro projector.
The power voltage for the projector is indicated on the identification
plate on the rear of the projector.
The projector input voltage is internally switchable between 120V
AC and 230V AC. Consult a
qualified service technician
to adapt
the input voltage to the correct voltage to that on the wall outlet.
This projector may be connected to an IT-power system.
ART N
o
-R9001300
V
-120/230V
I
-10/6Amp
Freq -60/50Hz
