Barco MDSC-8527, User Manual

Page: 14 / 64

R5914634 /01 MDSC-8527 14
2.1 Cover removal
To remove the connector cover
1. Gently press and hold the clips at the bottom right and left side of the connector cover.
2. Slide the cover downwards while holding the clips pressed.
Either press the two clips at once, or press and release one side of the cover first and then press
and release the other side.
2
1
Image 2–1
2.2 Interface connection
About
The MDSC-8527 can have multiple video inputs connected. Switching between the different inputs can be
done easily with a programmable key on the front front keyboard.
Futhermore, if more than one video source is connected, the Picture-in-Picture and Picture-by-Picture (PIP/
PBP) functionalities become available, allowing you to view two different video inputs at once. Please refer to
“Picture-in-Picture (PIP)”, page 33 and “Picture-by-Picture (PBP)”, page 33 for more information.
Beside the video input connections, the MDSC-8527 also has video output capabilities allowing you to loop-
through or duplicate all video inputs connected with the MDSC-8527 to another display, projector, video
recorder, ...
This chapter describes how to connect the different video interface types to the MDSC-8527.
2.2.1 MDSC-8527 SSTP version
To connect the interfaces
1. Connect one or more video source(s) to the corresponding video inputs of the display. For a list of
supported video inputs, see “Technical specifications”, page 56 .
2. SDI input loop-through: When the SDI video input is connected, an additional SDI video sink can be
connected to the SDI output.
3. Video output: The entire active image on the screen (including OSD) can be duplicated to a FHD (1080p/
1080i) signal on the DisplayPort output connector, to which an additional DisplayPort video sink can be
connected.
4. Connect the USB2.0 type B interface with a workstation to use the remote control protocol.
Display installation