Barco Matrix-PRO HD-SDI, Installation And Operator'S Manual

Page: 38 / 52

MatrixPRO
TM
16x Series
Manual #26-0301100-00/ Revision A
32
6.5 MATRIXPRO
TM
REMOTE COMMANDS
HELP Capabilities. Send list of commands available back in ASCII format
ALVL num lvl Input Audio Level.
AVTYPE mode AV Type. 0=A/V, 1=Audio, 2=Video
CLEAR Clear all matrix video and audio routings.
CSUMSTAT Display Main Code/RBF Checksum info
FDLY dly Field delay for RGB sync. Delay (dly) in milliseconds
FPLOCK en Locks/unlocks Front Panel control
GCLEAR grp Clears grouping information
GADD grp out in Add output, input to group
GDEL grp out in Remove output, input from group
IPCONFIG I3 I2 I1 I0 IP address configuration I3.I2.I1.I0
LOADRMP Places unit into loader mode for firmware upgrade
OMUTE out en Enable/disable audio mute on output.
OSTAT [out] Displays output status in ASCII.
PSTAT [num] Displays preset status in ASCII.
PRST num Saves current front panel configuration to a Preset location.
RPRST num Recall preset from a Preset location.
RNOV Recall Flash settings
RESETMP op Reset the MatrixPRO
TM
and recall saved Flash values op [R|F] Reset |
Factory Reset
RTEMP out in audio Route inputs to outputs. If output is in group, group is routed too.
SBAUD Sets Baud Rate. 0=19200, 1=28800, 2=38400, 3=57600.
SMODE mode [485id] Serial Mode. 0=RS232, 1=RS485. [485id] opt if RS232
SWITCH mode Switching Mode. mode = 0(RGB) 1(VSync) 2(Comp) 3(VREF In)
TAKE en en = 1 simulates a TAKE button pushed on the front panel (i.e takes
all prelim routes and makes it permanent). en = 0 simulates a CANCEL
button pushed
UNOV Save current settings to FLASH
VDLY dly Vertical Interval delay. Delay for # of VSYNCs seen before raising /CE.
Minimum is 1, max is 255
6.5.1 MATRIXPRO
TM
SERIAL COMMAND LIST/DESCRIPTION
Command:
HELP
Description: Displays the list of available command on a terminal emulator
Parameters: None
Example:
HELP (Returns the command list.)
Command:
ALVL num lvl
Description: Updates input audio level
Parameters: num - Input number; [1 - 16]
lvl - Audio level; [0 - 252]
Query:
ALVL? num
Returns the selected input audio level in the format:
=lvl
Example: ALVL 1 252 (Set input 1 audio level to 252. All outputs connected to
input 1 will have audio level of 252.)