Barco LED-PRO, User Manual

Page: 128 / 186

114 LED-PRO • User’s Guide
5. Upgrading Software
Serial Upgrade Method
pÉêá~ä=réÖê~ÇÉ=jÉíÜçÇ
„
Use the following steps to upgrade LED-PRO software using a serial connection to
your PC:
1. With the download complete, navigate to the target folder and double-click the
EXE to launch the installation shield.
2. Follow the prompts to install the upgrade package in the default folder. At the
conclusion of the procedure, a new path will be created under
Start > Programs >
Barco Folsom , and shortcuts will be added.
3. Connect the Diagnostic port on the back of the LED-PRO to the COM 1 port on
your PC. In Chapter 2, refer to the “ LED-PRO Rear Panel ” section on page 15 for
the location of the Diagnostic port.
4. Power-up the LED-PRO.
5. On the PC, click Start > Programs > Barco Folsom > LED-PRO Rev #.## >
LED-PRO Flash File Loader Rev #.## to launch the Flash Loader utility, as
shown below.
Figure 5-1. Flash Loader Utility
6. Click Communication > RS232 Config > Baud , and select 38400.
7. Click Communication > RS232 Config > COM Port , and select the COM port on
your PC to which the LED-PRO is connected. If no other programs are using the
port, the “
Established communications ” message appears at the bottom of the
Flash Loader.
8. To verify communications between the PC and LED-PRO:
a. In the loader program, click in the black terminal window area.
b. Note the condition of the status lights:
• DCD and CTS should be red.
Note Do not move or copy any files out of the target folder.
Note
If you have not used the COM 1 port on your PC, an error
message will be shown at the bottom of the Flash Loader.