Barco E-2621, Installation & User Manual

Page: 47 / 131

Installing the
Nio
drivers and software
Nio MKII 47
Put the
Nio
3MP/5MP display panel in
portrait
position before
installing the software.
If you wish to change the panel orientation later, the image
orientation will adapt automatically to the panel orientation
after
rebooting the PC
.
Note:
Both displays connected to a single display controller must
have the same physical orientation and resolution in order to be
attached to the Windows desktop.
Driver and software installation
To install your
Nio
Windows display controller driver and NioWatch
Software for the first time follow the steps below.
If you are reinstalling the drivers or installing a new driver release over
an existing driver release you may skip steps 2 and 3 below:
1.
Boot your system, and log in using an account with administrator
privileges.
2.
When the
Found New Hardware Wizard
comes up, click Cancel.
When the
System Settings Change
window asks you to restart your
computer, click
“No”
.
3.
Run the Barco Product Installation Wizard.
The Barco Product Installation Wizard should start automatically if
you insert the B
ARCO
N
IO
Display System Installation CD-ROM into
your CD drive
after
the operating system has started. If your CD
drive’s auto-run is not enabled or the Barco Product Installation
Wizard does not start automatically, you can run the Barco Product
Installation Wizard manually by following these steps:
a)
Click the
“Start”
button in the task bar.
b)
Click
“Run”
.
c)
Click
“Browse”
and browse to the root directory of the
B
ARCO
N
IO
Display System Installation CD-ROM and click on
the file,
“Setup.exe”,
and click
“Open”
.
d)
Click
“OK”
.