Barco E-2621, Installation & User Manual

Page: 34 / 131

Display controller installation
34 Nio MKII
Figure 5: PCI and RAID Controller Slots
Installing the BarcoMed N
IO
display controller
Install the BarcoMed N
IO
controller in your computer following these
steps:
1.
Turn off the power to your computer and disconnect the power
cord, however make sure that the computer chassis is
still
grounded
.
2.
Remove the chassis cover according to the manufacturer’s
instructions. Be sure to observe safety warnings.
3.
If you have decided to use the on-board VGA capabilities of the
BarcoMed N
IO
(see
Using the VGA capabilities of the
BarcoMed N
IO
display controller
on page 32), you
must now
remove
any VGA display controller(s) that are currently installed in
the computer or
disable
any VGA controllers that are integrated
into your PC’s motherboard.
4.
Install the BarcoMed N
IO
display controller into a free PCI slot,
either 64-bit or 32-bit (see figure 5, for examples of slots). Be sure
that the display controller is seated firmly in the slot.
5.
Secure the card to the chassis with the PC’s I/O panel mounting
screw, and replace the chassis cover.
6.
Connect the primary display to the connector marked “VID 1” on
the BarcoMed N
IO
display controller using the provided DVI cable