Barco DP2K-E series, User And Installation Manual

Page: 76 / 163

9. Communicator Touch Panel
9.2 Installing the Touch Panel interface
Necessary tools
• 17mm open wrench.
• 10mm open wrench.
How to install the Touch Panel interface onto the top of the projector?
1. Assemble the mounting plate and the swivel arm together as illustrated. First place the nut (1) upon the rod of the mounting
plate, then add the lock washer (2), then fasten the mounting plate and the swivel arm together. When the arm is mounted, turn
the nut (1) against the arm to secure the position.
1
2
Image 9-4
2. Slide a washer (4) over the base of the swivel arm (3) and insert the base of the swivel arm into one of the four possible mounting
holes (A & B) at the top of the projector.
Note: Which mounting hole to use depends on the operator preferences. In the illustration below the swivel arm is installed
into the mounting hole nearest by the Local Keypad of the projector.
A
B
3
4
Image 9-5
3. Place the Touch Panel interface upon the mounting plate of the swivel arm and fasten the two wing nuts (5) as illustrated.
72 R5906693 DP2K-E SERIES 19/06/2015