Barco DP2K-E series, User And Installation Manual, Page: 63 / 163

8. ICMP
8.6 ICMP HDD status LEDs
ICMP HDD status LEDs
5 4
Image 8-9
Status overview PWR/ERROR and READY LEDs:
4 5
HDD I/O RAID ICMP HDD Status
Off Off HDD idle / Disk in RAID OK.
Blinking Green Off HDD I/O activity / Disk in RAID OK.
Blinking Green
Blinking Red
HDD I/O activity / RAID rebuilding.
Off Red HDD idle / Disk error. See troubleshooting table below for curative actions.
Troubleshooting
Situation Solution
One disk failed (red LED) + RAID degraded .
The ongoing event is not interrupted.
Note: The disk status (RAID degraded) can be retrieved via the
(Web) Commander. See user guide of the (Web) Commander.
1. Switch off the power.
2. Replace the defect HDD with an original HDD spare part.
See procedure "Removing a HDD form the ICMP", page
65, and "Installing a HDD into the ICMP", page 66. Ensure
to insert the HDD
fi rmly.
3. Switch on the power.
Result: As soon the new HDD is detected by the ICMP the
rebuild of the RAID is started (Blinking red LED).
One disk failed (red LED) + Error 10580 “ local storage not
available ”.
Note: The disk status (Error code) can be retrieved via the
(Web) Commander. See user guide of the (Web) Commander.
1. Switch off the power.
2. Replace the defect HDD with an original HDD spare part.
See procedure "Removing a HDD form the ICMP", page
65, and "Installing a HDD into the ICMP", page 66. Ensure
to insert the HDD
fi rmly.
3. Switch on the power.
Result: As soon the new HDD is detected by the ICMP the
rebuild of the RAID is started (Blinking red LED).
Multiple disks failed (multiple red LEDs) + RAID broken .
Note: The disk status (RAID broken) can be retrieved via the
(Web) Commander. See user guide of the (Web) Commander.
1. Switch off the power.
2. Replace all defect HDDs with original HDD spare parts.
See procedure "Removing a HDD form the ICMP", page
65, and "Installing a HDD into the ICMP", page 66. Ensure
to insert the HDDs
fi rmly.
3. Switch on the power.
4. Start “RAID Initialize”. See user guide of the
Communicator.
Result: a new empty RAID is created.
All HDD LEDs remain off + Error 10580 “ local storage not
available ”.
Note: The disk status (Error code) can be retrieved via the
(Web) Commander. See user guide of the (Web) Commander.
1. Switch off the power.
2. Reseat all HDDs. See procedure "Removing a HDD form
the ICMP", page 65, and "Installing a HDD into the ICMP",
page 66. Ensure to insert the HDDs
fi rmly.
3. If problem remains try “RAID Initialize”. See user guide of
the Communicator. Note that all content will be lost!
4. If problem remains contact Service for further instructions.
R5906693 DP2K-E SERIES 19/06/2015 59