Barco CLM R10+ R90501001, User Manual

Page: 146 / 229

13. Projector control
Default Gateway
A router that serves as an entry point into and exit point out of a network. For example, a local network (LAN) may
need a gateway to connect it to a wide area network (WAN) or to the Internet.
MAC address
Media Access Control address. Unique hardware number, used in combination with the IP-address to connect to the
network (LAN or WAN).
What should be set up for an Ethernet address?
2 ways can be used to assign an address:
•
use the DHCP setting so that an automatic address will be assigned.
• Assign manually an IP address, Net-mask (subnet-mask), (default) gateway address.
-
Set the IP-Address fi eld to the desired value. This must NOT be 0.0.0.0 for static IP-Address assignment. The IP address
identi fi es a projector’s location on the network in the same way a street address identi fi es a house on a city block. Just as
a street address must identify a unique residence, an IP address must be globally unique and have a uniform format.
- Set the Subnet-Mask as appropriate for the local subnet.
- Set the Default-Gateway to the IP-Address of the local router (MUST be on the local subnet!) on the same network as this
projector that is used to forward traf
fi c to destinations beyond the local network. This must not be 0.0.0.0. If there is no
router on the projector’s local subnet then just set this fi eld to any IP-Address on the subnet.
13.4.2 DHCP setup
How to switch DHCP setting?
1. Press MENU to activate the menus.
2. Use the ▲ or ▼ key to select Projector control and press ENTER .
3. Use the ▲ or ▼ key to select Ethernet and press ENTER .
The Ethernet menu opens.
4. Use the ▲ or ▼ key to select DHCP .
5. Press ENTER to toggle the DHCP setting.
[ON] = DHCP is activated. Automatic assigning of an address is activated.
[OFF ] = DHCP is deactivated. A fi xed address will be used. (image 13-18, image 13-19, image 13-20)
Image 13-18
Image 13-19
Image 13-20
13.4.3 IP-address set up
How to set up?
1. Press MENU to activate the menus.
2. Use the ▲ or ▼ key to select Projector control and press ENTER .
3. Use the ▲ or ▼ key to select Network and press ENTER .
The Network menu opens.
142 R59770021 CLM R10+ 11/10/2010