41
R5900022 /18
ClickShare CS-100 series
Advantages
•
Less Wi-Fi access points allowing to better control the Wi-Fi spectrum.
•
Eliminates any security risks via ClickShare because all Base Units are in an isolated and separate (virtual)
LAN.
•
Easy management of all ClickShare Base Units in the separate (virtual) LAN, e.g. through their assigned IP
addresses.
•
If the network configuration allows it, mobile users remain connected to their current network when sharing
and have access to corporate environment and the internet. Enterprise network traffic is routed to the
dedicated ClickShare network for content sharing purposes.
How to setup via the Configurator
1.
Connect the Base Unit and browse to the
ClickShare Configurator
and log in.
2.
Select
Button
in the
System
menu and click
Edit settings
.
Select
External Access Point
from the drop down menu and select the preferred authentication mode and
fill out the details.
Click
Save Changes
. For more information, see “
”,
3.
Pair the Buttons again with the Base Unit.
4.
Optionally the Base Unit’s Wi-Fi can be set to Access Point or can be set to Off. For more info,
Setup via XMS
1.
Log in to XMS and go to the
Base Units
tab.
2.
In the device list select the Unit(s) for deploying network integration mode and click
Edit
in the top right
menu..
3.
Browse to
System
>
Button Connects To
in the configurator.
4.
Select
External Access Point
from the drop-down menu.
5.
Select the preferred authentication mode and fill out the details.
6.
Click
Save Changes
when finished.
7.
Re-pair the ClickShare Buttons with the updated Base Unit(s) to apply the new configuration
For more detailed information on how to use XMS, consult the XMS user guide.
4.11 Power connection
About power
This product is intended to be supplied by a UL Listed Power Unit marked “Class 2” or “LPS” or “Limited
Power Source” with output rated 12 VDC 1.5A min.
An external power adapter is delivered with the product.
Once the Base Unit is powered, it starts up. Then the power button can be used to switch on or off.
How to connect the external power adapter.
1.
Plug the barrel connector of the power adapter into the power input of the Base Unit.
2.
Slide a power input adaptor piece (US, CN, EU or UK) on the power adapter of the ClickShare . Use the
one which is applicable in your country.
1. Slide down the button on the adapter (1).
2. Insert the latch (2) of the adapter piece into notch (3)
Summary of Contents for ClickShare CS-100
