![background image](http://html1.mh-extra.com/html/barco/clickshare-cs-100/clickshare-cs-100_installation-manual_473945067.webp)
67
R5900022 /18
ClickShare CS-100 series
How to change
1.
Log in to the
Configurator
.
2.
Click
Display & Audio
→
Display & Audio
.
3.
Check or uncheck the check box next to Enable Audio.
Checked: audio is enabled.
Unchecked: audio is disabled.
4.
To select the audio output, click on the drop down box and select the desired audio output.
Jack: audio output via jack.
HDMI: audio output via HDMI.
5.
Click on
Save changes
to apply the new settings.
6.10 Wi-Fi settings
WARNING:
It is not allowed to operate the Base Unit outside its intended geographical region.
About Wi-Fi
A connection with the Base Unit can be made via a wireless connection. A fixed wireless IP address is used to
establish the connection.
The transmission power of the wireless signal can be reduced.
An overview of the current settings is given when
Wi-Fi Settings
is selected and operational mode is
Access
Point
.
Image 6–17 Wi-Fi settings
When operational mode is set to
Off
. The following info is given: “The wireless interface is disabled. Buttons
must be configured to connect to another Wi-Fi access point. Click
here
to go to the Button configuration
page”.
Summary of Contents for ClickShare CS-100
