Installation
User manual CCFD 2320
27
Figure 14
Cable routing
Routing the signal cables
•
Bind the cables in the connector compartment
together with the cable tie inside the connector
compartment.
•
Put the connector compartment cover back on the
display. Pay attention that the signal cables are
positioned under the bulge in the cover.
•
Push the cables into the clipses on the rear of the tilt
& swivel foot.
•
Bind the cables together above and under the foot,
by means of the 2 velcro strips attached to the inside
of the foot cover (packed inside the accessory box).
•
At last, put the foot cover back in place.
To put the foot cover in place:
1. Push the upper side of the cover onto the foot, so
that the hooks inside the cover are positioned right
under the bulges at the rear of the foot.
