Barco BarcoReality 909 Split Pack R9040040, Instruction Manual

Page: 31 / 58

AC Power connections
5 - 1
5976397 SPLIT PACK REALITY 909 09112001
5
AC POWER CONNECTIONS
AC Power cord
AC Power cord connection
Use the supplied power cord to connect your projector to the wall outlet. Plug the female power connector into the male connector
at the front side of the electronic block.
Preparing the power cord
As the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings identifying the terminals
in your plug, proceed as follows:
1 The yellow/green wire is ground and must be connected to the terminal in the plug which is marked by the letter E or colored
yellow and green.
2 The blue (white) wire is neutral and must be connected to the terminal marked with the letter N or colored black.
3 The brown (black) wire is the line and must be connected to the terminal marked with the letter L or colored red.
COMM. PORT
REMOTEREMO
TE
IRIR RS 232 OUTRS 232 OUT RS 232 IN
R G B
Comp / H-Sync V-Sync
R G B
Comp / H-Sync
S - VIDEO
75 Ohm
OFF - ON
75 Ohm
ON - OFF
75 Ohm
OFF - ON
75 Ohm
ON - OFF
red: standby
green: operation
red: standb y
green: operation
S - VIDEO
VIDEO
VIDEO
V-Sync
RS 232 IN
PORT 3
COMM. POR T PORT 3
PORT 4 / 5
PORT 4 / 5
PORT 2
PORT 2
PORT 1
PROJECTOR MODE
PROJECT OR MODE
PORT 1
ON OFF
ON OFF
POWER MAINS
800 periphals
800 periphals
This device complies with part 15 of the FCC rules.
Operation is subject to following two conditions (1).
This device may not cause harmful interference,
and (2) this device must accept any interference that
may cause undesired operation.
See installation instructions before connecting to the supply.
Voir la notice d' installation avont de raccorder au réseau.
See installation instructions bef ore connecting to the supply .
Voir la notice d' installation a vont de r accorder au réseau.
This device complies with par t 15 of the FCC rules .
Operation is subject to f ollowing tw o conditions (1).
This device ma y not cause harmful interf erence,
and (2) this device m ust accept any interf erence that
may cause undesired oper ation.
image 5.1
AC Power cord connection
POWER MAINS
image 5.2
Power cord plugs
CEE 7 Plug
Green and yellow : Ground
Blue : Neutral
Brown : Line
ANSI 73.11 Plug
Green and yellow : Ground
White : Neutral
Black : Line
AC Power
The power voltage
The power input voltage is autoranging between 100V (-10%) and 240V (+6%).
Following fuses are used:
2x T10A (Order number R314521)
1x F10A (Order number R314155)
For continued protection against fire hazard: replace with the same type of fuse and refer replacement to qualified service personnel.