Barco BarcoReality 909 Split Pack R9040040, Instruction Manual

Page: 38 / 58

Source connections
6 - 4 5976397 SPLIT PACK REALITY 909 09112001
RGB Analog source to port 3
Which signal to port 3 ?
Connect your RGB source with sync on green, composite or separate sync via an interface to Port 3.
Always use an interface (e.g. Barco Magik Interface R9828120) when a computer and local monitor have to be connected to the
projector as the signal cable coming from the computer is limited to 60 cm due to interferences.
The RGB analog input accepts only sources with a horizontal frequency of 32 kHz and higher.
To connect a source lower than 32 kHz, an optional d Limo Pro (R9828631) has to be installed.
Pin configuration D9 connector of the Analog input.
1 Not connected 4 GREEN 7 Ground RGBS
2 Ground RGBS 5 BLUE 8 Hor/comp. sync
3 RED 6 Ground RGBS 9 Vert. sync
Input selection port 3
With the RCU, press digit button 3
Settings on module level
In the case of this second RGB input there are three different settings:
1. 75 W Termination resistor
2. Blue in green switch
3. Force negative sync switch
Computer
Port on projector
Magik Interface
(R9828120)
to computer
to monitor
PORT 3
image 6.6
Port 3
S2
S1
R1
R21
R41
R81
R101
image 6.7
Second RGB module
S1 Force negative sync
(ON = Yes)
S2 Blue in green
(ON = Yes)
R1 Red
R21 Green
R41 Blue
R81 H-Sync
R101 V-Sync