background image

Exporting SureCross Radios. It is our intent to fully comply with all national and regional regulations regarding radio

frequency emissions. Customers who want to re-export this product to a country other than that to which it was

sold must ensure the device is approved in the destination country. A list of approved countries appears in the

Radio Certifications section of the product manual. The SureCross wireless products were certified for use in these

countries using the antenna that ships with the product. When using other antennas, verify you are not exceeding the

transmit power levels allowed by local governing agencies. Consult with Banner Engineering Corp. if the destination

country is not on this list.

Violating Warnings. The manufacturer does not take responsibility for the violation of any warning listed in this

document. Make no modifications to this product; any modifications to this product not expressly approved by Banner

Engineering could void the user’s authority to operate the product. All specifications published in this document are

subject to change; Banner reserves the right to modify product specifications or update documentation at any time. For

the most recent version of any documentation, refer to: 

www.bannerengineering.com

©

 2006-2014 Banner Engineering

Corp. All rights reserved.

Banner Engineering Corp Limited Warranty

Banner Engineering Corp. warrants its products to be free from defects in material and workmanship for one year following

the date of shipment. Banner Engineering Corp. will repair or replace, free of charge, any product of its manufacture

which, at the time it is returned to the factory, is found to have been defective during the warranty period. This warranty

does not cover damage or liability for misuse, abuse, or the improper application or installation of the Banner product.

THIS LIMITED WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES WHETHER EXPRESS OR

IMPLIED (INCLUDING, WITHOUT LIMITATION, ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A

PARTICULAR PURPOSE), AND WHETHER ARISING UNDER COURSE OF PERFORMANCE, COURSE OF DEALING OR

TRADE USAGE.

This Warranty is exclusive and limited to repair or, at the discretion of Banner Engineering Corp., replacement. IN NO

EVENT SHALL BANNER ENGINEERING CORP. BE LIABLE TO BUYER OR ANY OTHER PERSON OR ENTITY FOR

ANY EXTRA COSTS, EXPENSES, LOSSES, LOSS OF PROFITS, OR ANY INCIDENTAL, CONSEQUENTIAL OR

SPECIAL DAMAGES RESULTING FROM ANY PRODUCT DEFECT OR FROM THE USE OR INABILITY TO USE THE

PRODUCT, WHETHER ARISING IN CONTRACT OR WARRANTY, STATUTE, TORT, STRICT LIABILITY,

NEGLIGENCE, OR OTHERWISE.

Banner Engineering Corp. reserves the right to change, modify or improve the design of the product without assuming any

obligations or liabilities relating to any product previously manufactured by Banner Engineering Corp.

 

 

SureCross MultiHop Data Radio

 

www.bannerengineering.com - tel: 763-544-3164

 

Summary of Contents for SureCross DX80DR2M-H1













Reviews: