6 Reset the Sensor to Factory Defaults
Reset the sensor to factory default settings using one of two methods.
Note: If a factory reset is performed through the Banner Radar Configuration Software, the remote input
wire becomes disabled (factory default setting). If the sensor is returned to factory defaults by using the
remote input wire, the input wire remains enabled and the rest of the settings are restored to factory
defaults.
Reset Using the
Banner Radar Configuration
Software
Go to Sensor > Factory Reset. The sensor indicators flash once, the sensor is reset back to the factory default settings, and
a confirmation message displays.
Reset Using the Remote Input
Eight-pulse the remote input to apply the factory defaults.
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
6.1 Factory Default Settings
Setting
Factory Default
Distance Switch Point
9076 models: 24 m
2450 models: 40 m
N.O./N.C.
Normally Open
On Delay
0 ms
Off Delay
0 ms
Output filtering
50 ms-ON/500 ms-OFF
Remote input
Disabled
Signal Strength Threshold
1.0
R-GAGE
®
Q130RA Sensor
www.bannerengineering.com - Tel: + 1 888 373 6767
15
