6. After the filter is installed, place the Focusing Window back into the housing while inserting the Locking Clip into
the groove as shown.
C
B
Groove
7. Press the Focusing Window onto the housing to make sure that it seats correctly (no gap between the window
and housing). Rotate the window counter-clockwise at least two turns.
8. Replace the locking tab screw but do not tighten until you have set up and focused the sensor again.
Installing a Filter on the C-Mount Lens Model
To install a filter on the iVu Series sensor with C-Mount Lens, use the illustration as a guide and follow the steps listed
below.
CAUTION: Failure to follow these instructions may cause damage to your iVu Series sensor.
C-Mount Lens Models
D
C
A
B
E
C
A
C-Mount Lens
B
Lens Enclosure
C
Retainer Ring (optional)
D
Filter (optional)
E
Filter Retainer Ring Tool
NOTE: Filter Kits are available separately.
1. Remove the Lens Enclosure and Lens.
2. Install filter behind the retainer ring. Make sure it is fully seated.
3. Using the provided retainer ring tool, thread the retainer ring into the sensor until it firmly seats the filter.
4. Replace the Lens and Lens Enclosure on the camera.
CAUTION: Electrostatic Discharge
Avoid the damage that electrostatic discharge (ESD) can cause to the Sensor.
Always use a proven method for preventing electrostatic discharge when installing a lens or
attaching a cable.
1.2 Home Screen
The Home screen on the iVu Series sensor display is used to monitor inspections and to configure the sensor. Normally,
the part being inspected is centered on the screen.
iVu Barcode Reader (BCR)
10
