Banner EZ-SCREEN SLSP14-450Q88, Instruction Manual, Page: 42 / 59

7. Inspect the area near the defined area (including work pieces and the guarded machine) for reflective surfaces (see Adjacent
Reflective Surfaces on page 16). Remove the reflective surfaces if possible by relocating them, painting, masking or roughening
them. Remaining problem reflections will become apparent during the Trip Test.
8. Verify that power to the guarded machine is Off. Remove all obstructions from the defined area. Apply power to the EZ-SCREEN
Type 2 System. Latch Output models: (Manual Power-Up), both Alignment indicators will be flashing amber. Perform a manual
reset (open the reset switch for 1/4 second, then close it).
9. Observe the Status and Alignment indicators:
• Lockout: Status Blocked flashing red
• Blocked: Status Blocked On red Alignment indicators On, Off, or one of each Status Clear Off
• Clear: Status Clear On green Alignment indicators both On Status Blocked Off
• Latch: (defined Status Blocked On red Alignment indicators flashing amber area clear) Status Clear Off
10. A Blocked condition indicates that one or more of the beams is misaligned or interrupted. See the Alignment procedure in
Optical Alignment on page 26 to correct this situation.
11. After the green and amber Status indicators are On, perform the trip test ( Trip Test on page 28) on each sensing field to verify
proper System operation and to detect possible optical short circuits or reflection problems. Do not continue until the EZ-
SCREEN Type 2 passes the trip test.
Important: Do not expose any individual to any hazard during the following checks.
WARNING: Before Applying Power to the Machine
Verify that the guarded area is clear of personnel and unwanted materials (such as tools) before applying
power to the guarded machine. Failure to do so may result in serious bodily injury or death.
12. Apply power to the guarded machine and verify that the machine does not start up.
13. Interrupt (block) the
defined area with the supplied test piece and verify that it is not possible for the guarded machine to be
put into motion while the beam(s) is blocked.
14. Initiate machine motion of the guarded machine and, while it is moving, use the supplied test piece to block the defined area.
Do not attempt to insert the test piece into the dangerous parts of the machine. Upon blocking any beam, the dangerous parts
of the machine must come to a stop with no apparent delay.
15. Remove the test piece from the beam; verify that the machine does not automatically restart, and that the initiation devices
must be engaged to restart the machine.
16. Remove electrical power to the EZ-SCREEN Type 2. Both OSSD outputs should immediately turn Off, and the machine must not
be capable of starting until power is re-applied to the EZ-SCREEN Type 2.
17. Test the machine stopping response time, using an instrument designed for that purpose, to verify that it is the same or less
than the overall system response time specified by the machine manufacturer. A Banner Applications Engineer can recommend
a suitable instrument.
Do not
continue operation until the entire checkout procedure is complete and all problems are corrected.
EZ-SCREEN
®
Type 2 Light Screen
42 www.bannerengineering.com - Tel: 763.544.3164