Setting up ML Gateway / Programming 17
Restarting ML Gateway on factory-installed software
If a software update causes ML Gateway to fail (for example due to power failure during flash update), the unit can be restarted using the original
factory-installed software.
To do this, switch ML Gateway off, and while pressing the setup button, switch it back on. Release the setup button after 5 seconds. This will start
the system using the original factory software, but will not fix nor replace the ‘broken’ software. You need to log into the system and perform a
software upgrade to fix the broken software.
If you suspect that the failure is inherent to the latest software installed (and not a failure during the flash process), you can manually download an
earlier software version from BeoWise to your computer, and perform a software update from that file.
Software update complete
When it is confirmed that ML Gateway has the latest software, the next step is to define devices and resources. Please follow the procedure on the
next page.
Programming
Additional information
The programming section provides the opportunity to define
how BeoLink products and the home automation systems interact.
The programming section in ML Gateway consists of two main elements:
-
Devices
(including
Resources
for
BeoLink
,
Virtual buttons
,
Home automation system
)
-
Macros
Refer to the following pages for information about setting up devices and resources. Macros is not described since this is individually for each
home automation system.