International and national certifications
Automation Panel 1000 user's manual V2.00
185
10.3 Notes for the manual pursuant to radio approval
B&R products meet the EMC requirements for operation in the USA and Canada and comply with FCC and IC
regulations. Below are the corresponding "Radio Frequency Interference Statements" for the USA and Canada:
RF exposure statement
Complies with FCC and IC certifications
CE
Conformity
Additional to the Low voltage and EMC directive the complete end-device must
be conform to the radio equipment directive.
FCC and IC
B&R products satisfy EMC requirements for operation in the USA and Canada
and are compliant with FCC and IC regulations. This must be verified with every
device in which this B&R wireless board "RFM-2-NF and RFM-3-BTW" should
be installed. Corresponding "Radio Frequency Interference Statements" for the
USA and Canada:
USA:
Federal Communications
Commission (FCC)
This device complies with Part 15 of the FCC rules. Operation is subjected to
the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found comply with the limits of Class
A digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a commercial
environment. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. Operation of this equip-
ment in a resident area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
Canada:
Industry Canada (IC)
This device contains license-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s license-exempt
RSS(s). Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference re-
ceived, including interference that may cause undesired operation.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux CNR d’Innovation, Sciences et Développement économique
Canada applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de
brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélec-
trique subi, même si le brouillage est susceptible d'en compromettre le fonction-
nement.
Mexico:
Instituto Federal de Teleco-
municaciones (IFETEL)
Products with RFM-3-BTW and/or RFM-2-NF boards are approved for use in the USA and Canada. The types
can be identified by an adhesive label bearing the appropriate marks - identifiable by the information "Contains
FCC ID:" and "Contains IC:".
