Ping Starboard
. The starboard end mark on the start line panel
becomes solid green indicating it is set.
The start line end points are set and can be viewed on the Chart
panel and Start line panel.
Setting end points at cursor position
1.
Open the Chart panel and move the cursor to the position in
the chart where you want the port end point to be.
2.
Open the menu and select
Start line
,
Port end
, and then
Set
at cursor
.
3.
Repeat steps 1 and 2 for the starboard end point.
The start line end points are set and can be viewed on the Chart
panel and Start line panel.
Setting end points at coordinates
Select the
Set coordinate Port
and then the
Set coordinate
Starboard
menu options to enter the coordinates of the port and
starboard end points.
Setting end points from each other
Use the
Set from stbd Port
and
Set from port Starboard
menu
options to set the Range and Bearing of the end points from each
other.
Removing end points and the start line
Use the
Clear Port
or
Clear Starboard
menu options to remove
the start points. When both are removed, the start line is removed.
Race panel
| Vulcan Series Operator Manual
71
Summary of Contents for Vulcan Series
